Eiki LC-WIP3000 Manual do Proprietário descarregar pdf (Página 15)

Setting Up

Power ON / OFF

Turning On The Power

1. Make sure that power cord is firmly and

correctly connected to the projector.

2. The green Power indicator blinks slowly.

3. Remove the lens cover.

4. Press POWER button on the Touch Keypad

or the remote control to turn on the projector.

5. Rotate the focus ring to adjust the focus.

Turning Off The Power

1. Press the POWER button on the Touch

Keypad or the remote control. The "power

off" conﬁrmation message will appear.

2. Press the POWER button again while the

message is shown on the screen.

3. When the projector enters "Standby" mode,

the green Power indicator blinks slowly.

4. The projector cannot be turned on while red

"Lamp indicator" is blinking slowly in cooling

mode.

5. If you don’t use the projector for a long time,

remove power cord.

WARNING



Do not touch around the lamp cover and the

exhaust vents during use or just after use, since it

is too hot.

AC inlet

Outlet

Focus ring

WARNING



A strong light is emitted when the projector’s

power is on. Do not look into the lens of the

projector or look inside of the projector through

any of the projector’s openings.

CAUTION



Do not turn off the AC power for 120 seconds

after the lamp is turned on. Doing so could cause

premature lamp failure.

3.~4.

Active Area

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Comentários a estes Manuais

Sem comentários

Eiki LC-WIP3000 Manual do Proprietário Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores Eiki LC-WIP3000