Eiki LC-X70 Manual de Instruções descarregar pdf (Página 47)

APPENDIX

Remote Control Unit

does not work.

● Check batteries.

● Check ALL-OFF switch on Remote Control Unit is set to “ON”.

● Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.

● Make sure you are not too far from a projector when using Remote Control Unit.

Maximum operating range is 16.4’ (5m).

● Check transmitted signal mode from Remote Control Unit.

(See“SETTING” section on page 39.)

Problem: Try these Solutions

Wireless Mouse

function does not

work.

● Check cable connection between a projector and your computer.

● Check mouse setting on your computer.

● Turn a projector on before turning on a computer.

This symbol on the nameplate means the product is Listed by Underwriters

Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety

standards against risk of fire, casualty and electrical hazards.

The CE Mark is a Directive conformity mark of the European Community (EC).

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists

after following all operating instructions,

contact the sales dealer where you purchased the

projector or the service center.

Give the model number and explain the difficulty. We will advise you how to obtain service.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 55 56

Sem comentários

Eiki LC-X70 Manual de Instruções Página 47